Connect SPA-122 ATA

The Cisco SPA-122 ATA is an adapter that converts our digital VoIP signal to analog, allowing you to hook-up devices that require a traditional analog line such as fax machines. Follow the steps below to get this device connected.

1. Locate an open ethernet port near your fax machine and connect the included ethernet cable from the wall to the blue "Internet" port on the back of the ATA.
   
   1. If the ethernet port near your fax machine is already in use then unplug that device from the wall and plug it in to the yellow "Ethernet" port on the back of the ATA. Then follow step 1. The device that you unplugged will go offline until you complete these setup instructions.
      
   2. If you do not have an ethernet port near your fax machine at all then you may require a network drop. Contact your IT department or celito support.
      
      
2. Find the telephone cable that goes to the fax machine and plug it in to the grey "Phone 1" port on the back of the ATA.
   
   
   
3. Plug the provided power cord in to the round power input on the ATA.
   
   
   
4. The device will take several minutes to boot up. The status lights on the top will go through the following sequence:
   1. Power light comes on solid, then begins blinking slowly
   2. Internet light begins blinking rapidly. This indicates activity and it will continue to do this from now on.
   3. Line 1 and power lights go solid. Internet light continues blinking rapidly.